Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

PIX515E - Hardware failure?

Following a power outage at one of our sites (not on UPS) the PIX515E seems rather broken. It is unresponsive on the network and using he serial port at boot time it just shows the HW config and proceeds no further. Any attepmt to get into monitor mode (ESC) simply results in a hw diags menu appearing all of which run OK.

Our analysis is that the firmware has been corrupted.

Any views/suggestions? Is it possible to recover this box?

Regards...

146
Views
0
Helpful
0
Replies
CreatePlease to create content