Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

PIX515E stop after install new memory and VAC+ card

Hi, after we install new memory and VAC+ card to upgrade PIX515E from R version to UR version, the PIX515E stop boot procedure. there is no error message.

CISCO SYSTEMS PIX FIREWALL

Embedded BIOS Version 4.3.207 01/02/02 16:12:22.73

Compiled by morlee

32 MB RAM

PCI Device Table.

Bus Dev Func VendID DevID Class Irq

00 00 00 8086 7192 Host Bridge

00 07 00 8086 7110 ISA Bridge

00 07 01 8086 7111 IDE Controller

00 07 02 8086 7112 Serial Bus 9

00 07 03 8086 7113 PCI Bridge

00 0D 00 8086 1209 Ethernet 11

00 0E 00 8086 1209 Ethernet 10

00 11 00 8086 1229 Ethernet 11

What could the problem and how can I fix the problem? Thanks

1 REPLY
New Member

Re: PIX515E stop after install new memory and VAC+ card

I worked it out. just replace the battery.

130
Views
0
Helpful
1
Replies
CreatePlease to create content