Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX515E upgrade using monitor mode

I've upgraded from 7.0.(4)4 to 8.0.4(4) with intermediary upgrade of 7.2.4 however both upgrades were done in monitor mode before a reload. If 8.0.4(4) is running fine in RAM will it be OK to copy this image to flash, set boot system file and save config without having done so in the intermediary image upgrade?

2 REPLIES
Cisco Employee

Re: PIX515E upgrade using monitor mode

If you do not worry about preserving the config, then sure you can do that.

Those step by step upgrade procedure is only for preserving the config.

New Member

Re: PIX515E upgrade using monitor mode

That is what I thought and am glad to confirm. I think I read where a utility can be obtained from Cisco if I need to erase and start over due to corruption if that were to occur. I have the config backed up. Thanks.

131
Views
0
Helpful
2
Replies