Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Pix515e will not accept command

I have a Pix515e running Version 6.1(4)when I go to add access-list it allows me to add them giving no error, but when I do a Sh configuration it doesn't show what I have added.

I added the same lines to a Pix515e running version 6.3 and it works fine.

Do I need to do a write memory before I do a show configuration so that it will display what I have added?

1 REPLY

Re: Pix515e will not accept command

The show config command is equivalent to "show startup-config", if you din't issue a write mem after acl statement configuration it will not show in startup-config but it will show in " show running-config",you need to write mem to be able to see it in show config.

Rgds

Jorge

116
Views
0
Helpful
1
Replies