Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX525 and IE

Hi all,

How can i make PIX525 working through IE, Which program that should be added to PIX525 that make it working through IE?

best regards

thaar

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: PIX525 and IE

To use ASDM, you need to enable the HTTPS server, and allow HTTPS connections to the security appliance. All of these tasks are completed if you use the setup command.The security appliance allows a maximum of 5 concurrent ASDM instances per context, if available, with a maximum of 32 ASDM instances between all contexts. WebVPN and ASDM administration cannot be enabled on the same interface. If you enable WebVPN on an interface, then that interface cannot be used for ASDM.

Uset the below commands for configuring ADSM:

hostname(config)# http source_IP_address mask source_interface

hostname(config)# http server enable

hostname(config)# asdm image disk0:/asdmfile

Refer the following url for more info:

http://www.cisco.com/en/US/docs/security/asa/asa71/configuration/guide/mgaccess.html#wp1047288

1 REPLY
Silver

Re: PIX525 and IE

To use ASDM, you need to enable the HTTPS server, and allow HTTPS connections to the security appliance. All of these tasks are completed if you use the setup command.The security appliance allows a maximum of 5 concurrent ASDM instances per context, if available, with a maximum of 32 ASDM instances between all contexts. WebVPN and ASDM administration cannot be enabled on the same interface. If you enable WebVPN on an interface, then that interface cannot be used for ASDM.

Uset the below commands for configuring ADSM:

hostname(config)# http source_IP_address mask source_interface

hostname(config)# http server enable

hostname(config)# asdm image disk0:/asdmfile

Refer the following url for more info:

http://www.cisco.com/en/US/docs/security/asa/asa71/configuration/guide/mgaccess.html#wp1047288

117
Views
0
Helpful
1
Replies
CreatePlease login to create content