Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

pix525 - failover group command - not available

does pix 525 version 8.0 has a failover group command available? I have the active/active license on it.

2 REPLIES

Re: pix525 - failover group command - not available

Are you asking about assigning the context to a failover group? If it is then the command is 'join-failover-group ' under the context mode. This command should be supported in Version 8.x. If you have a different requirement could you clarify that.

HTH

Sundar

New Member

Re: pix525 - failover group command - not available

got it...I need to enable multiple context first with this command, "mode multiple"

these are now available commands:

failover group 1

failover group 2

any basic config for A/A failover would be appreciated. Thanks ...

107
Views
0
Helpful
2
Replies