Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Please guide me how to configure DMZ on ASA

Hi,

This is sivaji and it will be gratefull if you give the support on this.

We have datacenter and all the servers located in datacenter. From dataceter to our office we have point to point line conneted to Cisco routers. We have ASA in datacenter and DMZ port connected to router which going to our office.

I need the example configuration for this setup.Please help me on this.

regards

Sivaji.P

1 REPLY
Silver

Re: Please guide me how to configure DMZ on ASA

The configuration of the DMZ in the device can be broadly divided into these three parts:

Interface Security Level -- Traffic is allowed from a higher security interface to a lower security interface by default. But, the reverse case is blocked

Translation Rules -- Translation rules can be dynamic nat, global, or static.

Traffic Permission Rules -- Traffic Permission rules are access-list and access-group rules applied in the configuration of the firewall to permit the traffic to go through the interface.

For DMZ configuration use this document it contains examples.

http://www.cisco.com/en/US/docs/security/asa/asa72/getting_started/asa5550/quick/guide/dmz_n.html

289
Views
0
Helpful
1
Replies