I don know if anyone could help me... the following i
s my configuration....
INTERFACE ETHERNET 0/0
NO IP ADDRESS
INTERFACE ETHERNET 0/0.1
IP ADDRESS 192.168.21.0 255.255.255.248
INTERFACE ETHERNET 0/0.2
IP ADDRESS 192.168.21.17 255.255.255.248
Problem is that i cannot ping the interface 0/0.1 from my remote link which is connected to this outside. Is there anything i am missing...?
When assign the outside ip address then it is pingable. Otherwise not.....doi have to assign an ip on the 0/0 interface.....? or what.....
My outside interface is serving to remote wan locations. It is required that both traffic should come to the firewall on each different vlan. As per the physical connectivity of the outside interface , the outside interface is connected to 3rd party STM equipment. There is no trunking feature on that equipment. Please advice....
Since you are configuring sub-interfaces on Ethernet0/0, then it needs to be connected to a device port that supports trunk, and should be dot1q trunk in particular. If it doesn't support trunk, then you can't configure subinterfaces on ethernet 0/0. You can only use ethernet0/0 as a normal access port.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...