I Have Connected the RS Straight Through cable with 2 DB 9 Female to both end PC/Console and VPN Concentrator 3005 with the following settings as described in cisco document â¦.I've attached image for cables that I use
â¢ Bits per sec: 9600
â¢ Data bits: 8
â¢ Parity: none
â¢ Stop bits: 1
â¢ Flow control: Hardware
But the nothing appears on the console even the garbage not exist either
What's the Problem? How can I overcome on this issue
Are the DB9s real RS232 ? if so fine, is the cable straight through CAT5 ? perhaps try another cat5 cable, if cable is fine then next would be are you usign correct COM1 or whatever COM port the system is using? have you try using
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...