Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 
New Member

port access

i have a device on my INSIDE IP addresses that use port 5001

none of my inside computers can connect to that device!

any ideas?

PIX Version 6.3(3)

interface ethernet0 auto

interface ethernet1 auto

nameif ethernet0 outside security0

nameif ethernet1 inside security100

enable password RaLOExOLbdJiPZVa encrypted

passwd 2KFQnbNIdI.2KYOU encrypted

hostname pixfirewall


fixup protocol dns maximum-length 512

fixup protocol ftp 21

fixup protocol h323 h225 1720

fixup protocol h323 ras 1718-1719

fixup protocol http 80

fixup protocol rsh 514

fixup protocol rtsp 554

fixup protocol sip 5060

fixup protocol sip udp 5060

fixup protocol skinny 2000

fixup protocol smtp 25

fixup protocol sqlnet 1521

fixup protocol tftp 69


access-list OUTSIDE_IN permit icmp any any echo-reply

pager lines 500

mtu outside 1500

mtu inside 1500

ip address outside dhcp setroute

ip address inside

ip audit info action alarm

ip audit attack action alarm

pdm logging informational 100

pdm history enable

arp timeout 14400

global (outside) 1 interface

nat (inside) 1 0 0

access-group OUTSIDE_IN in interface outside

timeout xlate 0:05:00

timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 rpc 0:10:00 h225 1:00:00

timeout h323 0:05:00 mgcp 0:05:00 sip 0:30:00 sip_media 0:02:00

timeout uauth 0:05:00 absolute

aaa-server TACACS+ protocol tacacs+

aaa-server RADIUS protocol radius

aaa-server LOCAL protocol local

http server enable

http inside

no snmp-server location

no snmp-server contact

snmp-server community public

no snmp-server enable traps

floodguard enable

telnet inside

telnet timeout 5

ssh timeout 5

console timeout 0

dhcpd address inside

dhcpd lease 3600

dhcpd ping_timeout 750

dhcpd auto_config outside

dhcpd enable inside

terminal width 200


: end

My configuration is below!


Re: port access

If I understood you correctly, both client and server are on the inside, in this case the traffic would not even hit the firewall.

New Member

Re: port access

this is a home network. the pix is connected to my cable modem. so ethernet 0 is my outside. ether0 is my inside. on the indide i have 6 devices PS3, xbox360, 4 laptops and 1 slingbox.

my question is pertaining to the slingbox. the slingbox is a device that lets me watch tv from any where, and it uses port 5001. how do i allow port 5001 access to the outside world for that internal IP.

CreatePlease to create content