Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Port forward w/ASA 5505 running 9.2(2) ?

Greetings all,

I am having trouble crafting the proper commands to successfully expose a specific internal host to the internet on a range of ports.

I thought I had it working correctly after I upgraded to 9.2(1), but I think there must have been a bug or two with that release, because I seem to have lost my config and can't get it back, nor do I remember the commands I used.

I have a single, public (dynamic) IP address for the 5505, and I have done the NAT/ACL for a different internal host, but it was using a single port.

For this host, it is 192.168.1.24 and I need to expose TCP and UDP on ports 8082 through 8083. The range seems to be causing me a bit of trouble. When doing the rules, I don't need to change the port numbers, the same range internal will also be the external range.

Could someone please give me the proper NAT and ACL statements to use? I am a little confused on the NAT/PAT and which to use when.

Thanks in advance!

-Rob

2 REPLIES
New Member

Hi,This may help : https:/

Hi,

This may help : https://supportforums.cisco.com/document/132066/asa-nat-83-nat-operation-and-configuration-format-cli

Or let us know if you face any issues after reading the above.

Best Regards,

Yadhu

Regards, Tony http://yadhutony.blogspot.com
New Member

HiDid you find a solution for

Hi

Did you find a solution for your problem? I can't wrap my head around this as well.

If you got a working solution, I'd be grateful if you'd share it :)

 

1183
Views
0
Helpful
2
Replies