Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Port mapping

Hello guys,

I have system which works on Server/Client basis on a specific port number (udp 5000). The Server version of the system is in a remote location where as the client system is installed on more than 1 PC. Our network has a PIX firewall where it has one public address only (eg: 22.22.22.22).

Is there anyway I can let all the client systems to connect to the server using the same prot number (UDP 5000) but with single public IP?

Rgds

Nimalraj

1 REPLY
New Member

Re: Port mapping

If I'm reading you right, if you don't buy any more IPs then you could use

static (inside,outside) tcp interface outside 5000 X.X.X.X 5000

so if you sent any traffic to 22.22.22.22 it would go to the server (X.X.X.X)

263
Views
0
Helpful
1
Replies
CreatePlease to create content