Port redirection for Asa in transparent mode

[Akaffou Aristide Akaffou]

Hi,

Can we make port redirection when we configuring Asa in transparent mode.

Regars

Aristide

[Jouni Forss]

Hi,

I have not personally had much dealings with the ASA in Transparent mode.

According to the ASA Configuration Guide it seems that NAT should be supported in Transparent mode.

Naturally the configuration format depends on the software level you are using on the ASA. What is your software level?

- Jouni

[Akaffou Aristide Akaffou]

Thank you,

version 9.0 in Asa 5510

Regards

Aristide

[Jouni Forss]

Hi,

Well the basic format for Static PAT (Port Forward) would be

object network STATIC-PAT

host

nat (inside,outside) static service

Naturally "object" and interface names might be different.

Again, I have not used Transparent firewalls other than for testing and have not even tried configuring NAT with them so I dont know will this work.

The Configuration Guides Guidelines and Limitations section doesnt mention anything else for Auto NAT / Network Object NAT (the above configuration) than

• Supported in Routed and Transparent mode
• Have to define the source and destination interface in the "nat" command
• Cant use "interface" PAT (since do IP configured on the actual interface in Transparent mode)

- Jouni

[Akaffou Aristide Akaffou]

Thank you journi

[Jouni Forss]

Hi,

Let us know if it worked when you had the chance to test it out

- Jouni

[Akaffou Aristide Akaffou]

Ok, I will back to you

Aristide