Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Ports will not open in ASA 5505

We are trying to open ports 400 and 9799 on a 5505.I added these into the ACL and ran a port test but they still say closed. Do I have to add anything else other than a ACL statement?           

5 REPLIES
New Member

Ports will not open in ASA 5505

Hello Mike

After adding into acl did you apply that acl on the interface?

If yes and still you see the issue then  send the output of packet tracer and also your config

regards

Gaurav

Ports will not open in ASA 5505

Post your config so we can assist.

Please rate replies and mark question as "answered" if applicable.

Please rate replies and mark question as "answered" if applicable.
New Member

Ports will not open in ASA 5505

Heres what I have

access-list acl_out extended permit tcp any host 64.53.58.229 eq 9799

access-list acl_out extended permit udp any host 64.53.58.229 eq 9799

access-list acl_out extended permit udp any host 64.53.58.229 eq 400

access-list acl_out extended permit tcp any host 64.53.25.229 eq 9899

access-list acl_out extended permit udp any host 64.53.58.229 eq 9899

access-list acl_out extended permit tcp any host 64.53.58.229 eq 400

New Member

Ports will not open in ASA 5505

Hello Mike

The access list looking good.

But did you apply this command

if your public inerface name is outside

access-group acl_out in interface Outside

Also if it still did not work then probably it could be hitting a deny statement.

Can you send the output of this

packet tracer input outside tcp 4.2.2.2 2048  64.53.58.229 400 detailed

regards

Gaurav

New Member

Re: Ports will not open in ASA 5505

Gaurav,

I havent applied the command. I will try that. Thanks

106
Views
0
Helpful
5
Replies
CreatePlease login to create content