Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

prefix list not filtering type 3 lsa on ASA

Hi all

i am unable to filter type 3 lsa using the prefix list. scenario is as shown below :

r1 >> in - asa - out >> r2

r1 is configured with two loopbacks 10.1.1.1/24 and 10.1.2.1/24. it is connecing to asa on the inside with ip of 1.1.1.1/24.

r2 is on the outside.

i am running ospf process 10 on the loopback interfaces of r1 and on the inside of asa.

the loopbacks are in area1 and the f0/0 of r1 and e0/0 of asa are in area 0.

ospf process 20 is running on the ouside of asa and r2.

since r1 is an ABR, i am summarizing the 10.1.1.0/24 and 10.1.2.0/24 routes o 10.1.0.0/16. asa learns abou this summarized route.

now when i try to filter this type 3 lsa on the asa it does not wrk.

the config on r1 is :

router ospf 10

net 10.1.1.1 0.0.0.0 a 1

net 10.1.2.1 0.0.0.0 a 1

net 1.1.1.1 0.0.0.0 a 0

area 1 range 10.1.0.0 255.255.0.0

the config on the asa is as follows:

int e0/0

nameif inside

ip add 1.1.1.2 255.255.255.0

int e0/1

nameif outside

ip add 2.1.1.2 255.255.255.0

prefix-list 10 deny 10.1.0.0/16

rouer ospf 10

net 1.1.1.2 0.0.0.0 a 0

area 0 filer-list prefix 10 in ---- (i believe this shud filter out the 10.1.0.0/16 network- but i still see the route for 10.1.0.0/16 in the routing able of asa)

router ospf 20

net 2.1.1.2 0.0.0.0 a 0

can somebody please explain me where i am going wrong with this scenario.

waiting for reply.

thanks

kiri.

291
Views
0
Helpful
0
Replies
CreatePlease login to create content