Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Problem understanding active/standby problem

Hi

I've got a an active/standby pair of ASA's and I've been given a point-to-point circuit to connect into it. My problem is that I only have one ip address but when creating the interface I don't know what to do about the standby configuration. Currently all my other interfaces have the following:

ip address x.x.x.1 255.255.0.0 standby x.x.x.2

What can I do about this?

Thanks

Dan

  • Firewalling
1 REPLY
New Member

Re: Problem understanding active/standby problem

Dan

If you only have one public IP then failover on the outside wont work (it wont monitor it). You can set the failover to monitor other interfaces i.e inside dmz.

Im guessing this is what you are asking?

If not then please clarify and elaborate.

HTH

97
Views
0
Helpful
1
Replies
This widget could not be displayed.