Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Problem with an ASA.

Hello,

I have an ASA and I'm trying to implement something like “load sharing” between 2 ISP's.

I tried to do “dual ISP”, but that's not what I intended to have…

I tried to implement “favoring static routes based on reachability”, but I did not succeed.

Somehow this last implementation is, I think, very near of what I need. The problem with this is that it has a limitation… it doesn't let me put 2 default routes pointing to 2 different interfaces (I mean, putting the traffic that leaves the ASA in 2 different interfaces), like this:

!

route outside 0.0.0.0 0.0.0.0 190.3.14.5 1 track 1

route dmz3 0.0.0.0 0.0.0.0 200.100.73.11 1 track 2

!

Can some one help me?

Thanks in advance,

Rui

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Problem with an ASA.

ASA cannot do loadbalancing like a router.

You cannot have two active defalt routes. Only one will be active.

for redundancy you can use the following

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00806e880b.shtml

2 REPLIES

Re: Problem with an ASA.

ASA cannot do loadbalancing like a router.

You cannot have two active defalt routes. Only one will be active.

for redundancy you can use the following

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00806e880b.shtml

Community Member

Re: Problem with an ASA.

Hello,

when you said "load balanced" you minted to say "load share", wasn't it so?

Thanks,

Rui Capao

107
Views
0
Helpful
2
Replies
CreatePlease to create content