Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PRSM - Import Failed when Importing ASA/CX Config

I am sure there is something I am missing here, but I have the system installed, and configured.  I am able to access it via the URL, login, make adjustments, etc.  However, when I log into PRSM, and attempt to import the ASA/CX, it verifies credentials, I accept the certificates and after spinning for a bit on "Importing configuration from your ASA CX device" it throws an error saying "Import Failed"  "The read operation timed out"

 

Obviously, there's a communication error somewhere, but I can't find where it might be.  The PRSM server is on a different subnet, but they are both on the Internal LAN.

 

Any input would be greatly appreciated.

 

Thanks,

 

Mark

7 REPLIES
Hall of Fame Super Silver

What are the PRSM versions on

What are the PRSM versions on the management server and ASA/CX? The former should be equal to or greater than then latter.

New Member

Hi Marvin, The version of

Hi Marvin,

 

The version of both PRSM and the CX are 9.1.3(13).  The ASA version is 9.1(2).  Do I need 9.1(3) on the ASA OS as well?

New Member

Hi Marvin, I upgraded the CX

Hi Marvin,

 

I upgraded the CX and PRSM to the latest 9.2 release as well as the firewalls to 9.1(4) since I noticed that the latest 9.2 release fixed a bug relating to HA firewalls.  Now, when attempting to add the device, I get an error stating that it cannot communicate with the ASA CX SSP.  When I login to the console of the PRSM virtual alliance or the CX, I am able to ping both ways without issue.

 

Any ideas?  I'm at  a loss.  There also doesn't seem to be much out there regarding this message.

 

Thanks,

 

Mark

Hall of Fame Super Silver

That is odd. I've labbed it

That is odd. I've labbed it to a single CX from PRSM and it worked fine. I don't have an HA pair to test on but I've seen it done.

Perhaps you should open a TAC case on it.

New Member

Thanks Marvin, I thought TAC

Thanks Marvin,

 

I thought TAC is where I was headed.  I created a case and will post the results once I have an answer from them.

 

Mark

New Member

Hi Mark,Do you got a solution

Hi Mark,

Do you got a solution for this problem? Running into the same problem. I got a firewall in between and I'm seeing that the connection immediately being closed by the CX module. 

 

regards,

Sander

New Member

No solution yet.  Created a

No solution yet.  Created a TAC case, worked for a couple of hours.  Collected a ton of logs and was escalted to the BU.  They called and checked some things but still it does not work.  Collected more logs and sent them to them.  Haven't heard from them in a couple of days.  I will be sure to post a solution if I get one though.

126
Views
0
Helpful
7
Replies