Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

RA VPN ph2 not working- Removing peer from correlator table failed, no match

Dear Colleagues

Please suggest the missing configuration- ASA 5525, 9.1 sw

I am getting below syslog, with debug crypto isakmp

Sep 30 16:17:47 [IKEv1]Group = defaultragroup, Username = myvpn, IP = 213.133.216.168, QM FSM error (P2 struct &0x00007ffecc8423a0, mess id 0x8f389b93)!

Sep 30 16:17:47 [IKEv1]Group = defaultragroup, Username = myvpn, IP = 213.133.216.168, Removing peer from correlator table failed, no match!

Sep 30 16:17:47 [IKEv1]Group = defaultragroup, Username = myvpn, IP = 213.133.216.168, Session is being torn down. Reason: Phase 2 Mismatch

I am attaching

sh run tunnel-group

sh run crypto map

and sh run,

My Access VPN group Policy is defaultragroup

local username is myvpn

ip pool 10.200.41.1-10.200.41.14

1 ACCEPTED SOLUTION

Accepted Solutions
Super Bronze

RA VPN ph2 not working- Removing peer from correlator table fail

Hi,

You could try adding

crypto dynamic-map RAVPNmap 65534 set ikev1 transform-set ESP-3DES-SHA ESP-3DES-MD5

Though I am not sure why there are multiple "dynamic-map" configuration on your ASA to begin with.

- Jouni

2 REPLIES
Super Bronze

RA VPN ph2 not working- Removing peer from correlator table fail

Hi,

You could try adding

crypto dynamic-map RAVPNmap 65534 set ikev1 transform-set ESP-3DES-SHA ESP-3DES-MD5

Though I am not sure why there are multiple "dynamic-map" configuration on your ASA to begin with.

- Jouni

New Member

RA VPN ph2 not working- Removing peer from correlator table fail

hello

i found the problem and fix it, thanks for reply

1472
Views
0
Helpful
2
Replies