Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Reassembly limit exceeded

Hi, wonder if anyone could help with this issue... we have recently upgraded to version 8 from version 6 on PIX

When connected to Oracle servers over a VPN tunnel it bombs out with errors, looking on the PIX log (attached) showed a reassembly limit is exceeded. I've looked on the web and found a work around is to remove 'inspect rstp'

i have done this but the errors persists

It did'nt happen on version 6.3 any ideas?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Reassembly limit exceeded

Please remove " inspect sqlnet " too.

Do rate if it resolves the issue.

Regards,

Sushil

7 REPLIES

Re: Reassembly limit exceeded

Please provide a running configuration of your device also.

You can try this command:

set connection embryonic-conn-max 16384

Cisco Employee

Re: Reassembly limit exceeded

Please remove " inspect sqlnet " too.

Do rate if it resolves the issue.

Regards,

Sushil

Cisco Employee

Re: Reassembly limit exceeded

Jmoss..removing Inspect wont help..you are getting reassembly limit exceeded error because tcp-proxy function/Inspection is enabled..and as TCP Proxy is mandatory for certain inspected protocols SIP, Skinny, H.323,RTSP disabling it wont help...

your problem is this CSCsl15229

Rate if this was helpful...

Cisco Employee

Re: Reassembly limit exceeded

Jmoss..removing Inspect wont help..you are getting reassembly limit exceeded error because tcp-proxy function/Inspection is enabled..and as TCP Proxy is mandatory for certain inspected protocols SIP, Skinny, H.323,RTSP disabling it wont help...

your problem is this CSCsl15229

Rate if this was helpful...

New Member

Re: Reassembly limit exceeded

ok great at least we are onto something. I've searched the bug toolkit and it says that the workaround is to not inspect rstp which i've tried but to no avail

we are on code 8.0(4), I only want to cure this one bug as everything else is fine. What version should we move to?

Cisco Employee

Re: Reassembly limit exceeded

this was a feature enhancement request...you may go to any of these codes..

8.0(4.1)

8.2(0.141)

8.1(101.6)

8.1(1.10

plz rate if it helps !

New Member

Re: Reassembly limit exceeded

Guys i've removed the inspect sqlnet and it's ok now

we will however move to a later version of code asap to fix this bug

thanks all for your help with this

318
Views
5
Helpful
7
Replies
CreatePlease to create content