Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Reboot after sh arp comand

Having a pix 506 and its look like has some but could not figure out .

Every time when we out sh arp command then its reboot with out any output results.

Running on following Ver 6.3 (5)

1 REPLY
Silver

Re: Reboot after sh arp comand

Usually, administrators do not need to manually manipulate ARP entries on the PIX. This is done only when troubleshooting or solving network connectivity problems.

98
Views
1
Helpful
1
Replies