when I migrated the ASA config from 8.2 to 8.3, in all groups the group members has been replaced by the IP address object. However, the "name" for this object has been migrated, but there is the "object network name" configuration missing.
What I can do now is that I can open the new created object in the ASDM, search for the object with this IP address and then enter the object name I had before. When I apply the config, ASDM then creates the object and replaces all affected objects in all groups, by replacing the object group memeber "network-object host hostname" with "network-object object hostname".
Do you know if there exists an automated way, which checks all the groups for members "network-object host", creates the "object network" and replaces the "network-object hosts" with "network-object object" within the group? As long we have a lot of groups which contains partially > 50 members, this really would be helpful.
Is there anyone who faced the same topic, what would be the best way to get the named objects again within a group?
What I figured out now is that I can add a faked ACE in the ACL, one ACE for each object. With this ACE, at least the network object has been created for all objects. But neverless, the members in the groups are still not updated, at the moment I only see the way that I upate each group manually.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...