Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Redirect multiple ports to (1) IP on a PIX 501 ver. 6.3(5)

I am trying to forward a range of ports ex. 1024-2048 to (1) internal address using statics? Is there an easy way?

4 REPLIES
Silver

Re: Redirect multiple ports to (1) IP on a PIX 501 ver. 6.3(5)

Unfortunately, there is no easy of doing this. We would need to put indpendent static commands for each port. :-(

Hope this answers your question.

Regards,

Vibhor.

Green

Re: Redirect multiple ports to (1) IP on a PIX 501 ver. 6.3(5)

I assume you're forwarding other ports on that same address. But, if you're not using this address for anything else, you could just forward all ports and write an acl to only allow 1024-2048.

New Member

Re: Redirect multiple ports to (1) IP on a PIX 501 ver. 6.3(5)

Thank you. Unfortunately is does answer my question. Is there a limit to the number of statics that can be entered into a PIX 501.

Silver

Re: Redirect multiple ports to (1) IP on a PIX 501 ver. 6.3(5)

As such, there is no limit defined. Logically, a static statement would take around 120 bytes of memory. So you could use as many as they fit into the memory on your PIX.

Regards,

Vibhor.

217
Views
3
Helpful
4
Replies
CreatePlease login to create content