cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
453
Views
3
Helpful
4
Replies

Redirect multiple ports to (1) IP on a PIX 501 ver. 6.3(5)

briannctrl
Level 1
Level 1

I am trying to forward a range of ports ex. 1024-2048 to (1) internal address using statics? Is there an easy way?

4 Replies 4

vitripat
Level 7
Level 7

Unfortunately, there is no easy of doing this. We would need to put indpendent static commands for each port. :-(

Hope this answers your question.

Regards,

Vibhor.

acomiskey
Level 10
Level 10

I assume you're forwarding other ports on that same address. But, if you're not using this address for anything else, you could just forward all ports and write an acl to only allow 1024-2048.

briannctrl
Level 1
Level 1

Thank you. Unfortunately is does answer my question. Is there a limit to the number of statics that can be entered into a PIX 501.

As such, there is no limit defined. Logically, a static statement would take around 120 bytes of memory. So you could use as many as they fit into the memory on your PIX.

Regards,

Vibhor.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: