Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Redundant/Load balanced NAT on ASA

Hi.

Is there a way of having a single Public IP address and NAT'ing to 2 different IP addresses. Either loads balanced or one as primary and the second in the event of failure??

Basically I would like to do the simplest job of the CSS on an ASA.

To be honest even the load balancing isn't required. Its more important to NAT to one IP generally and then if that IP is down NAT elsewhere.

HELP!

Thanks.

1 REPLY
Cisco Employee

Re: Redundant/Load balanced NAT on ASA

Sorry. That is not possible. That would be overlapping. We do not support that. It has to be manual or you would have to use CSS Content Service Switch.

186
Views
0
Helpful
1
Replies