Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Renaming an interface on a FWSM

i need to rename an interface for one of my DMZ's, if i just use the nameif command with the new name, will that change the name for the access-group and the routes.

2 REPLIES

Re: Renaming an interface on a FWSM

No worries

It will change the name for all the relevant commands. Such as

access-group

Nat related commands

telnet

ssh

route

etc....

Syed

New Member

Re: Renaming an interface on a FWSM

Ummm,

Very bad advice especially if you are running 3.2.

I did that a while ago and just applying "nameif" doesn't change the name. If you remove the existing name and apply a new one using "no nameif oldname" "nameif new name" "exit" it removes your access-group commands associated with that interface

137
Views
0
Helpful
2
Replies
CreatePlease to create content