Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Return ASA 5505 to factory default

I purchased a used 5505 on ebay.  I already have 2 others purchased new which work fine, and have done all configurations on them via ASDM and have been quite happy.

This one was shipped from ebay locked down completely it seems.  I do have console access and have performed the following steps:

en

write erase

reload

All ports are still marked as shutdown, no ASDM access

Could someone give me commands to run via the console so I can connect to this via ASDM please?  Current config is attached.

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Green

Return ASA 5505 to factory default

You can use the factory-default command to set the ASA back to factory default.

http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/start.html#wp1055130

Please rate any helpful posts

--

Please remember to rate and select a correct answer
4 REPLIES
VIP Green

Return ASA 5505 to factory default

You can use the factory-default command to set the ASA back to factory default.

http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/start.html#wp1055130

Please rate any helpful posts

--

Please remember to rate and select a correct answer
VIP Purple

Return ASA 5505 to factory default

In addition to the way by setting the ASA to factory-default you can also run the "setup"-command from the console-session to configure the ASA for ASDM-access. There you can specify all the parameters as you want them. Both ways will work.

-- 
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni


--
Don't stop after you've improved your network! Improve the world by lending money to the working poor: http://www.kiva.org/invitedby/karsteni
VIP Green

Return ASA 5505 to factory default

Do you require any more assistance with this?

Please rate any helpful posts.

--

Please remember to rate and select a correct answer
New Member

Return ASA 5505 to factory default

Sorry for not responding earlier.  This is now fixed.  Thank you, and I appreicate the assistance.

226
Views
0
Helpful
4
Replies
CreatePlease to create content