Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Reverse proxy rule

Hi ,

I have a PIX 525 E in HSRP (active and standby mode)

I have a trusted network attached to Inside interface of noth FW,I have REVERSE PROXY server which is also connected to the DMZ inteface of the both FW.

Now my requirement is to give access to the global users to access my servers which is in Trusted area through the REVERSE PROXY,meant the request has to hit the REVERSE proxy,then the reverse proxy has to direct to the servers in the TRUSTED area,then the reply has to again go back to the user through the REVERSE PROXY.

I just need to know what NAT and ACL are required to achieve this.

Please help me.

Thanks and Regards,

S.Venkataraman.

1 REPLY
New Member

Re: Reverse proxy rule

please describe your Q. with interface and ip address of users / reverse proxy / servers.

like:

pix interface inside 10.0.0.1 /24

users on insiede 10.0.0.0 /24

pix interface reverse proxy ....

144
Views
0
Helpful
1
Replies
CreatePlease to create content