Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

RFC1918 - ACL error message

Attempting to install an ACL on my inside of PIX to deny these RFC1918 (10., 172.16., and 192.168.)addresses from eminating from the inside.

Getting this error msg in my console prompt, and have never seen it before.

ERROR:IP address,mask (10.0.0.0,0.255.255.255) doesn't pair.

PIX 525 running vers 7.2

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: RFC1918 - ACL error message

use normal masks - not reverse masks in pix/asa OS.

2 REPLIES
Gold

Re: RFC1918 - ACL error message

use normal masks - not reverse masks in pix/asa OS.

Community Member

Re: RFC1918 - ACL error message

Thanks, one of the security guys here says the same thing. I was going to try netmasks instead of inverse masks but didn;t...all the doc said to stay with inv masks...thx.

285
Views
0
Helpful
2
Replies
CreatePlease to create content