Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

route-inject on FWSM - can I inject to more than one interface??

Hi

I recently found the beautiful route-inject feature and thought that all my dreams had come true. However it seems that I can only inject routes to one interface, not more, I get the following message

eg:

route-inject

redistribute static access-list routes1 interface inside

redistribute static access-list routes2 interface outside

ERROR: This route-inject redistribute type is already configured.

You must first remove the previous configuration.

Am I being a doughnut, or does anyone know if it's on the road map to allow pumping routes to more than one interfaces MSFC??

cheers

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: route-inject on FWSM - can I inject to more than one interfa

Hi.

Unfortunately, no there is no way to have multiple redistribute static statements. in the config guide it's mentioned that  you can have only one:

http://www.cisco.com/en/US/docs/security/fwsm/fwsm40/configuration/guide/ip_f.html#wp1140903

actually per type (static, nat, connected etc..) you can have only one.

Regards,

Fadi.

2 REPLIES
Bronze

Re: route-inject on FWSM - can I inject to more than one interfa

Hi.

Unfortunately, no there is no way to have multiple redistribute static statements. in the config guide it's mentioned that  you can have only one:

http://www.cisco.com/en/US/docs/security/fwsm/fwsm40/configuration/guide/ip_f.html#wp1140903

actually per type (static, nat, connected etc..) you can have only one.

Regards,

Fadi.

New Member

Re: route-inject on FWSM - can I inject to more than one interfa

cheers

611
Views
0
Helpful
2
Replies
CreatePlease to create content