Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Router888 as firewall and OWA exchange 2007

Hi to all,

I have a router 888 used to access to SHDLS and as firewall, I try to publish a Exchange 2007 OWA, I do the NAT for port 443 and open the port on firewall, but when I try to connect to the url (https://IPaddress/owa) I obtain a generic error "404 not found", inside the router on the LAN OWA works fine, I think is it a problem on firewall inspection, any body know the problem and the solution?

Thank you very much

Augusto

3 REPLIES
New Member

Re: Router888 as firewall and OWA exchange 2007

From internet do telnet publicip-OWA 443  , or use some onlnie port scanner site to do this for you.

you should get simillar screen as you get when you do this on internal ip. if not then you NAT/Firewall rules are incorrect

New Member

Re: Router888 as firewall and OWA exchange 2007

Hi,

The port 443 is open (I try also open 80), I think the problem occur when exchange redirect the url to its web application.

Thank

Augusto.

New Member

Re: Router888 as firewall and OWA exchange 2007

I'm solved... I'm stupid...

Thank

Augusto

362
Views
0
Helpful
3
Replies
CreatePlease to create content