Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Routes on PIX 515e

Dear all,

All routes which i configured on my PIX 515E are:

route outside 1
route outside 1
router rip
default-information originate
distribute-list default_rip_out_acl out interface inside

But, when i mahe sh route i found the following:

Primary-PIX-HO#    sh route

Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
       D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
       N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
       E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
       i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
       * - candidate default, U - per-user static route, o - ODR
       P - periodic downloaded static route

Gateway of last resort is to network

S [1/0] via, outside
R [120/1] via, 0:00:03, inside
R [120/1] via, 0:00:03, inside
R [120/1] via, 0:00:03, inside
R [120/1] via, 0:00:03, inside
R [120/1] via, 0:00:03, inside
C is directly connected, inside
S [1/0] via, outside
                                [1/0] via, outside
C is directly connected, faillan
C is directly connected, outside
S* [1/0] via, outside

from the last output results, how network has two entries form this line [1/0] via, outside
                                [1/0] via, outside
I got confused so much.


Re: Routes on PIX 515e


From the output of your config, there's no static route to configured on the PIX.

Can you post the output from the ''show run route''?


Cisco Employee

Re: Routes on PIX 515e

It apears like ECMP - (equal cost multiple path) but, how it got into the routing table as static route, I am not sure.

Are those the only two routes that you show when you issue "sh run route" or you see more than that.


Community Member

Re: Routes on PIX 515e

I confused so much as done withyou.

Primary-PIX-HO# sh run route
route outside 1
route outside 1

CreatePlease to create content