Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

routing based on tracking different interface

hello everyone,

the network scenario is as follow

Internet Edge router--E0--Router 28XX --E0--ATM Router 38XX --fiber pvc--ISP.

i wanted to divert my default route (internet traffic) to the ISP.

The default routes has been added in internet edge router pointing towards the 28XX and in 28XX towards 38XX ATM router.

The connection between 28XX and 38XX is Ethernet connection which will never goes down so my 28XX router will always through the packets towards 38XX.

What i wanted is that whenever the ATM PVC goes down, my 28XX should divert the traffic to the next lower metric route which is my redundant path to the ISP.

end result should be - 28XX should use secondary path to ISP when primary is down eventhough it has been not connected to the ISP. (should track the ISP ATM PVC to take decision for secondary route).

Any suggesion with config examples will be highly appreciated.

ragards,

aryan

2 REPLIES
Silver

Re: routing based on tracking different interface

I think the following dial backup document will help you.

http://www.cisco.com/en/US/tech/tk801/tk133/technologies_tech_note09186a0080093c6d.shtml

Green

Re: routing based on tracking different interface

114
Views
0
Helpful
2
Replies
CreatePlease login to create content