Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Routing between 2 VPN Tunnels

I need some documentation/examples of how to setup the following routing.

I have a PIX501 and I want to setup 2 vpn tunnels. Both tunnels will take different paths (frame relay network & verizon wireless data network) to get to the same VPN3000 Concentrator.

The traffic on the inside interface of the 501 needs to be able to take either tunnel to get to the remote destination (a network attached to the VPN3000). Not neccasarily load-balanced but a backup type scenario. Is this something I can use static routes for or would OSPF be better? How do you setup the VPN3000? Is there a better option?

1 REPLY
Silver

Re: Routing between 2 VPN Tunnels

Use the following documents for Routing between 2 VPN Tunnels for PIX 501 and VPN 3000

Cisco PIX 500 Series Security Appliances Configure

http://cisco.com/en/US/products/hw/vpndevc/ps2030/tsd_products_support_configure.html

Cisco VPN 3000 Series Concentrators Configure

http://cisco.com/en/US/products/hw/vpndevc/ps2284/tsd_products_support_configure.html

120
Views
0
Helpful
1
Replies
CreatePlease to create content