Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

RTSP using NAT on ASA 5540

I have a streaming server setup with a private IP behind an ASA 5540. I've given the server a static public NAT address. Using ACL I've allowed in port 554. When trying to remotely stream from the remote client to the NAT'd server, the server gets the 554 request, but seems unable to setup the UDP stream back to the client. If the client is behind the firewall, everything works fine. Any ideas?

3 REPLIES
Cisco Employee

Re: RTSP using NAT on ASA 5540

enable Inspect RTSP in ASA

Community Member

Re: RTSP using NAT on ASA 5540

thanks for the reply. I have actually tried it with 'inspect RTSP' on and off. Same result.

Community Member

Re: RTSP using NAT on ASA 5540

Turns out to be an issue on the streaming server. Thanks for the response.

271
Views
0
Helpful
3
Replies
CreatePlease to create content