Title says it for the most part - I am having problems with default WAN on my SA540 w/ firmware 1.21 so I'm shiftinng the load over to the optional WAN port. I have 3 alias IP that worked fine on the default WAN port but none of them work on the optional WAN port. I have configured the alias WAN setting; assigning the IPs to the optional WAN and have rebooted the SA540 just to see if that made any difference (no joy).
Any ideas? Getting a bit frustrated with this unit - only had it 2 weeks.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...