Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

same-security-traffic

What is the use of having same-security-traffic permit intra interface when the traffic between same interface hosts are allowed by default.

1 REPLY

Re: same-security-traffic

Hi Aksher

This command is widely used for IPSEC traffic, for enabling Spoke-To-Spoke VPN. Lets say that you have a Site-To-Site VPN tunnel which ends at your outside interface. Consider them as "the two hosts" at outside. By default, traffic between these tunnels is disabled. And the above command permits the traffic enter and exit the same interface.

Regards

165
Views
0
Helpful
1
Replies
CreatePlease to create content