If we have an ASA with an exsiting default gateway (on a point to point connection with no Internet access) and we want to add an actual Internet connection for remote monitoring and management what we would need to do to make the ASA reachable via SSH as far as default routes go. I know we would have to assign the IP address to the interface of teh ASA that it is plugging into but how do we handle teh fact that there is already a default route on the ASA that sends all traffic across the point to point connection?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...