Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Secondary failing to respond to SNMP poll

FWSM secondary seems to stop responding to snmp polls during replication. Is this expected behavior or symptomatic of somthing else?

1 REPLY
Anonymous
N/A

Re: Secondary failing to respond to SNMP poll

If the snmp requests are reaching the FW and it's not responding, you should see syslogs.

There are reasons why it may not respond, mostly having to do with resource

utilization. Obviously, that should not normally be a problem on the standby FW.

If you don't already see these, you may have to enable standby logging.

If that still doesn't point you in the right direction, then you will need to collect a sniffer trace on the same subnet as the secondary FW along with accompanying syslogs from the same time period

251
Views
0
Helpful
1
Replies
CreatePlease to create content