Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

secondary IP address on an interface - how?

I've a PIX-515E running 7.2.2 and I'm trying to create a secondary IP address on the outside interface. It's like having eth0 and eth0:0 on Linux.

If I run "ip address ..." in config-if mode, it just replaces the existing address.

I'm not sure what else to try.

1 REPLY
Community Member

Re: secondary IP address on an interface - how?

477
Views
0
Helpful
1
Replies
CreatePlease to create content