cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
334
Views
0
Helpful
2
Replies

Simple Pix Question

murphyw
Level 1
Level 1

Hi everyone,

I was wondering, if i issue a trace command on the pix and it times out, how can i stop it going through the full 30 attempts ?

1 Accepted Solution

Accepted Solutions

srue
Level 7
Level 7
2 Replies 2

srue
Level 7
Level 7

try ctrl-c

Little odd that because i am sure i tried it. Anyhow, just tried again and it works. Thanks very much....

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card