Best way to see if it is fine is with the show failover command, that will tell you if the standby Unit is Ready to take over. In multiple context scenario, you can see it by goups as well. You can check if the standby Group is ready. If it has any kind of problems it will show you that is on fail state.
To test the bounce, you can do, "no failover active" on the active Unit (Single Mode) "No failover active grou 1/2" (Multiple context.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...