08-07-2012 12:51 AM - edited 03-11-2019 04:39 PM
I have to connect an ASA with 2 core switches in network as above shows. so i need to configure one interface as an active and other one is backup.
core switches are configured with HSRP. During any failure with primary link(1000M) need to LAN traffic passthrough backup link (100M). Please some one help me to reach this. I can't configure any VLAN interface in ASA , it doesn't allow.....
Solved! Go to Solution.
08-07-2012 01:30 AM
I think the redundant interfaces should also work when connected to two different switches:
Edit: I just see that your interfaces have different speeds. Not sure if that works as both member-interfaces of the redundant interface have to be of the same physical type.
08-07-2012 12:57 AM
You can't configure a single ASA to 2 core switches because ASA is like router where interfaces are routed interface. You can configure 2 ASA with each ASA connects to each core switch. But not a single ASA to 2 core switches.
08-07-2012 01:14 AM
Thank you very much.
08-07-2012 01:30 AM
I think the redundant interfaces should also work when connected to two different switches:
Edit: I just see that your interfaces have different speeds. Not sure if that works as both member-interfaces of the redundant interface have to be of the same physical type.
08-07-2012 01:37 AM
Karsten is right, you can configure redundant interfaces. I completely have forgotten about this option.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: