Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

SIP Inspection

HI,

I have ASA 5510 withc csc module, i need to enable sip trafic (Udp 5060), the sip inspected by default, i opened the sip port from public to the Gatway ( private ip) in both direction but i cann't connect.

Note taht i use Static NAt for Gatway here under outr configuration

static (inside,outside) 82.10.229.100 10.10.100.8 netmask 255.255.255.255

service-policy global_policy

Class-map inspection_default

inspect sip

access-list outside permit udp any 82.10.229.100 eq sip

access-list outside permit tcp any host 82.10.229.100 eq sip

access-list inside permiy host 10.10.100.8 any

kindly advise

regards

1 REPLY
Anonymous
N/A

Re: SIP Inspection

SIP is an ASCII-based, application-layer control protocol that can be used to establish, maintain, and terminate calls between two or more endpoints. Like other VoIP protocols, SIP is designed to address the functions of signaling and session management within a packet telephony network. Signaling allows call information to be carried across network boundaries. Session management provides the ability to control the attributes of an end-to-end call.

345
Views
0
Helpful
1
Replies
CreatePlease to create content