Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Slingbox port forwarding

Greetings -

Trying to access my slingbox from the internet. Unable to do so. I just want to make certain that my forwading looks good.

I miss anything essential from this snippet on my pix 501?

access-list SLINGBOX permit udp any interface outside eq 5001

access-list SLINGBOX permit tcp any interface outside eq 5001

static (inside,outside) tcp interface 5001 10.0.0.254 5001 netmask 255.255.255.255 0 0

static (inside,outside) udp interface 5001 10.0.0.254 5001 netmask 255.255.255.255 0 0

access-group SLINGBOX in interface outside

I assume this looks fine. If so my problem lies elsewhere ..

grc.com shows that port 5001 is open

2 REPLIES
New Member

Re: Slingbox port forwarding

Are you seeing the hitcount on the ACL being incremented?? Are you obtaining an ip address via dhcp for your Internet connection??

New Member

Re: Slingbox port forwarding

Actually Yes I am seeing a hit count when I run a show access-list command. That is why I was confused on it was not functioning as expected.

However I resolved this issue. I simply had to "reset" the Slingbox device. I was questioning myself on the access-list commands as I am a bit rusty - thus why I posted it to this forum where as the folks here have a more of a clue then I do ;)

Thanks for replying!

940
Views
0
Helpful
2
Replies
CreatePlease to create content