Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

snmpwalk on FWSM multi-context

Hi, can somebody drop me the snmpwalk command to get infos from a FWSM context.

My customer tried a lot and does not get info from a context.

to address context admin:

snmpwalk -v2c -c communityi§admin FWSMhostname     
.1.3.6.1.4.1.9.9.109.1.1.1.1.5.1                        
Timeout: No Response from FWSMhostname  

If he addresses the FWSM without context, then it works, so udp161 is open:             
snmpwalk -v2c -c communityi FWSMhostname     
.1.3.6.1.4.1.9.9.109.1.1.1.1.5.1                        
SNMPv2-SMI::enterprises.9.9.109.1.1.1.1.5.1 = Gauge32: 0

Regards Guenther
.                                                     

  • Firewalling
Everyone's tags (3)
3 REPLIES

Re: snmpwalk on FWSM multi-context

Why do you want to put the context name in the snmp-walk command? Each context will have his own IP address space (or at least a unique IP Address), you can just use each context's IP address to run a snmp-walk on it. Please explain your requirement a bit more.

Regards

Farrukh

New Member

Re: snmpwalk on FWSM multi-context

Hi, thanks for your response. We already use IP addresses and it works. My customer wanted to use the hostnames but now agreed to use the IP.

Regards Guenther

Re: snmpwalk on FWSM multi-context

Hello

I'm sure you had this in mind already, but you could add all the FWSM Context IPs with different names in DNS (or the hosts file) and use them (if that fulfills the requirement).

Regards

Farrukh

666
Views
0
Helpful
3
Replies