08-06-2013 11:02 PM - edited 03-11-2019 07:22 PM
I have two ASA5510. I want to make failover between the two firewalls. However, when I use the command "show version", the display shows that the Failover is disabled. Anyone can help me?
Here is the output of "show version":
Licensed features for this platform:
Maximum Physical Interfaces : Unlimited
Maximum VLANs : 50
Inside Hosts : Unlimited
Failover : Disabled
VPN-DES : Enabled
VPN-3DES-AES : Disabled
Security Contexts : 0
GTP/GPRS : Disabled
SSL VPN Peers : 2
Total VPN Peers : 250
Shared License : Disabled
AnyConnect for Mobile : Disabled
AnyConnect for Cisco VPN Phone : Disabled
AnyConnect Essentials : Disabled
Advanced Endpoint Assessment : Disabled
UC Phone Proxy Sessions : 2
Total UC Proxy Sessions : 2
Botnet Traffic Filter : Disabled
This platform has a Base license.
08-07-2013 12:00 AM
Hello Liwei,
Security Plus license is required on both units in order to enable failover,
Check my blog at http:laguiadelnetworking.com for further information.
Cheers,
Julio Carvajal Segura
08-15-2013 12:42 AM
Thank you very much. I will let you know if it works.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: