You would need to remove the NAT statements and then re-add them in the order you want them to appear. The ASDM does it the same way but makes it easier by you just having to move the NAT rule to where you want it and apply...the ASDM does the rest. If you set your ASDM to show the commands before they are applied you will see how the ASDM does this. The setting is under Tool > Preferences and select Preview commands before sending them to the device
Please remember to select a correct answer and rate helpful posts
Please remember to rate and select a correct answer
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...