Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Source = Group of address

Hi, I need to create an access-list on ASA 5540 and the source of traffic must be a range of ip address.

How can I do that?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Source = Group of address

I would create a network object group with the required IP addresses and use this group for the source of your access-list:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00800d641d.shtml#net

Hope this helps.

2 REPLIES

Re: Source = Group of address

I would create a network object group with the required IP addresses and use this group for the source of your access-list:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00800d641d.shtml#net

Hope this helps.

Community Member

Re: Source = Group of address

Hi Eddie,

thank you. That was exactly what I was looking for.

Regards

115
Views
0
Helpful
2
Replies
CreatePlease to create content