Hi, my question is how can I make a source NAT within a Static PAT Rule? Static PAT changes only the Destination addresses and not the Sources. Background is that for routing issues the original sources should be hided behind the interface ip.Is ithis possible? And if yes, how? Thanks.
Thanks for the answer. I do a simple Port Forwarding on teh outside interface ip address to some internal hosts. That works quite easy with Static PAT. But my question is how can I achieve that the public addresses (sources) will never be seen on the real servers in the internal network. I will hide them (NAT) behind the interface ip of the e.g. internal interface. Must I build a second NAT Rule for that ? Who can help me?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...